To adjust pos-a-loc: {see reference drawings on bottom of page}
A: Remove access panel/or inside the door pad, to gain access to the latch module
B: Loosen screws on the cable hold down bracket.
C: Pull cable until all slack is taken up then back off cable about 1/32” to 1/16”
then retighten screws.
D: Adjust set screw on pos-a-loc to 1/16” to 3/32” gap between arm & screw,
Note: If pos-a- loc does not catch when the door is in open position then the cable is too tight.
If pos-a-loc does not release when handle is pulled then the cable
is too
loose.
Note: If you have questions concerning the door please contact P.T.L. ENGINEERING and we will be glad to assist you. Phone# (810) 664-2310 or e-mail